Macro XL Tutorial (Original DS)

Items you will need:

 

Step 1 – Remove the back of the DS

This is a fairly simple step. Using the tri-wing screwdriver, removed the screws from the points marked in red below.

IMG_20150513_173627After the screws are removed simply lift the rear of the shell to reveal the innards of the DS. Once opened, remove the screws marked in red.

Once removed disconnect the Wifi antenna cable, and the ribbon cables marked in red. Do not remove the motherboard yet, first lift up the bottom screen large ribbon cable to reveal two smaller cables below it. Remove those as well. These two ribbon cables are removed by pulling the brown locking mechanism forward. Do it slowly and softly, it is fragile (if you break it you can fix it with somewhat of a workaround). Once these are all removed you can remove the shoulder buttons and lift the motherboard from the shell.

Step 2 – Solder the resistor

With the motherboard out you are ready to solder the resistor! Get your 330 OHM resistor. If you are using an SMT resistor I would recommend getting some tweezers for this, as they are freaking tiny.

Soldering these is difficult (mine are rarely perfectly straight. The easiest way I’ve found is to pool solder on your two points, then lay one side of the resistor on the pools. When you heat the first side with your soldering iron it will suck the resistor in. Repeat with the other side and it will do the same, then the resistor will be level and soldered.

The points you are soldering to are marked in red below, they are LEDC2 and LEDA2. The orientation of the resistor doesn’t matter.

That is all you need to do to run the DS headless. You can plug the bottom screen in and test it if you’d like.

Step 3 – Removing the top screen

In this tutorial I am only installing one speaker (the right one). If you would like to use both left and right then just solder the the left speaker point as well.

First, remove the covers from the areas marked below, then remove the screws.

After the screws are removed pry the back of the screen off to reveal the inside.

IMG_20150513_181112Remove the screws holding the two small boards in. Now you have two options here. If you have 30 gauge kynar wire you can just use that, if not, remove the longer black and red wires connecting these two boards and solder them to the speaker as seen below.

IMG_20150513_181411You can then either wrap this connection in electrical tape, or just put a dab of hot glue on it to insulate it.

Now you can remove the top screen housing entirely. Remove the screw seen below

IMG_20150513_235632

Once removed, you will have to pull the hinge out of both sides. See the images below.

Once these are removed the top of the screen will come free. Then just wiggle the ribbon cable out.

Step 4 – Installing Speakers

Now you’re ready to install the speakers, reference the image below again for the proper points. This tutorial only installs the right speaker.

Solder your speakers to points:

  • Right Speaker + (Red): SPR0
  • Left Speaker + (Red): SPL0
  • Speaker GND (Black): U1-GND

You can now test it if you’d like. Plug the bottom screen back in. It should work like this:

Step 5 – Glue the speaker down

Now, flip the motherboard over to reveal the back. This part is super simple. If you have a hot glue gun, plug it in and wait for it to heat up. Then glue the speaker down in the area marked below. Double-sided tape will also work if you don’t have a glue gun.

That’s all. It should work now! Soon I will have a tutorial up for cutting and filling the case. But that’s all you need to do for the bare minimum. If you don’t need a speaker you could just put it back together and play like it is, just with headphones.

 

Leave a Reply to Anthony Thomas Cancel reply

Your email address will not be published.

*